EMISAR DA1K link >>> EMISAR DA1K 21700 LED FLASHLIGHT W/LUME X1 DRIVER *CUSTOM BUILT-TO-ORD – JLHawaii808
Emisar DA1k will have the new Lume X1 drivers, D4k and D1k will have the option to use the Lume X1 drivers
LUME X1
Notes & General Specifications
● 40W high-efficiency constant-current boost driver, >90% efficiency, over 95% max efficiency
● The Lume X1 is a high-power driver - for best performance, recommended to use low ESR, high CDR flat-top 21700 batteries such as Molicel P42, P45, P50, Samsung 50S, 40T, or Vapcell T50
● Output voltage: 12V (for 4S arrays, or multi-die emitters such as GT-FC40, XHP35, etc.), 9V (for 3S arrays such as 3S3P E17A), or 6V (for 2S emitters such as XHP70/50 etc.). Voltage and current configured via BOM adjustment
● ESD protection
● AVR32DD20 MCU including 3-pin UPDI flashing pads
● Ultra Dynamic Range - constant current brightness range >50 million: 1
● Anduril 2 open-source firmware
● Reverse Polarity Protection
● RGB and/or Switch AUX LEDs supported
● Dimensions: 24.0mm diameter, 1.6mm thickness, 4.0mm component max-Z-height (for driver cavity)